Wago 750-673 WAGO I/O-SYSTEM 750 Function and technology modules
Stepperservo DC 70V 7,5 A, No. of digital Outputs: 2, No. of Outputs: 1 Stepper Motor (2 phases), Counter depth: 32 Bit, Sensor connection: A, /A, B, /B, C, /C, Sensor frequency: 1 MHz, Sensor supply: DC 5 V, 300 mA, short-circuit-protected, Quadrature decoder: 4-fold report, Input filter: 100 ?s software filter can be installed, Switching frequency max.: 5 Hz; inductive load acc. to IEC 947-5-1, DC 13, Type of load: resistive/inductive (max. 2H)/Lampen, Functions: Positionieren/Rampen in sin2/fliegender Sollwertwechsel/Drehmomentkontrolle
The 750-673 is an intelligent servo stepper controller with on-board power driver and incremental encoder evaluation to control 2-phase stepper motors up to 70V/7.5A.
The 64 times microstepping prevents step losses due to resonance in the acceleration phases and reduces wear on the mechanical parts.
The controller features vector control that, together with the incremental encoder, contributes to an efficient and dynamic rotation speed characteristic.
Six configurable inputs for start/stop, end-stop, reference, jog/tip, etc., can be directly processed by the internal software without delay.
Two outputs can be linked with internal functions or used freely.
Versatile functions, such as positioning with different acceleration slopes, command tables, camshaft controller, auto referencing and other event-dependent properties provide this controller with a wide spectrum of possible uses.
The programmer's interface is the same for all WAGO stepper controller modules.
Compatible with RS-485/RS-422, common GND with motor voltage and control voltage
DI 1: Drive stop (preset)
DI 2: Reference input
DI 3: Jog switch in positive direction
DI 4: Jog switch in negative direction
DI 5: Limit switch in positive direction
DI 6: Limit switch in negative direction
DO 1: Target reached (preset)
DO 2: Error
Inputs and outputs can be freely reconfigured.