Wago 750-523 WAGO I/O-SYSTEM 750 Relay Output Module
1-Channel Relay Output module, output: 1-normal-open contact potential-free, Actuator connection: 1x (1-conductor), Switching voltage max.: AC 440 V, Switching current max.: 16 A, Pull-in time max.: 8 ms, Drop-out time max.: 4 ms
A connected actuator or load is switched via the relay output module.
The 24VDC supply is derived from the power jumper contacts to trigger the relays.
The switched status of the relay is shown by the manual switch (1/0).
The operating mode can be set using a manual/automatic selector switch.
The mode status is indicated by an LED and via status bits in the process image.
Coil triggering is interrupted. Actuation only via the red manual operating switches.
The relay is operated via the control system. Manual status changeover via manual operating switch is canceled by the control system in less than 500ms.
The manual switch can also be used without 24V supply to switch the output ON.
The relay meets both international standards of IEC and DIN EN 61810 part 1 /VDE 0435 part 201 as well as overload and short circuit requirements of IEC and DIN EN 61036 /61037.