Wago 750-627 WAGO-I/O-SYSTEM 750 System Modules
Bus Extension End Module in conjunction with th module 750-628 (coupler module for bus extension), Buscoupler connection: 1x RJ-45 socket, no. of coupler modules: up to 10
The end module for the internal data bus extension 750-627 is attached to the end of the I/O terminal block like the standard end module 750-600. The block is terminated with the module, to which a connecting cable can be attached with an RJ-45 connector.
Power to the internal electronics is supplied via the internal bus. Together with at least one coupler module for the internal data bus extension 750-628 the module forms a functional unit. The fieldbus coupler/controller carries out all diagnosis and commissioning tasks.
Installation note Attention:
To ensure safe, reliable operating states when using the internal data bus extension 750-627/-628 these states must be registered prior to startup with the following couplers or PLCs (refer to manual for supported couplers/PLCs). You must use the "WAGO Extension Setting" software for this (download: www.wago.com).
Please complete the manufacturing number matrix on the right-hand side of the couplers when updating the firmware and internal operating parameters.
shielded copper wire (ETHERNET patch cable) 4x 2x 0.25 mm², twisted pair, double shielding
Wago 16-channel Digital Input, DC 24V, 0,2 ms, high-side switching, 1-wire connection, with Power jumper contacts
Wago 16-channel Digital Output, DC 24V, 0,5A, high-side switching, with Power jumper contacts, short-circuit-proof
Wago 16-channel Digital Output, DC 24V, 0,5A, low-side switching, with Power jumper contacts, short-circuit-proof
Wago 4-channel Analog Input, adjustable, for Sensor types: Pt100 (preset)/Pt200/Pt500/Pt1000/Ni100/Ni120/Ni1000 (TK6180/TK5000), Potentiometers: 0 Ohm-1,2 kOhm, 0 Ohm-5 kOhm, resolution: 0,1°C, 0,01°C (-50-150°C, Pt1000, Ni1000), 2-/3-/4-wire connection