Wago 750-670 WAGO-I/O-SYSTEM 750 Specialty Modules
Stepper Controller, RS-422/DC 24 V, 20 mA, no. of inputs: 2 (DI1, DI2), no. of outputs: 1 channel (2 differential outputs A1, A2, B1, B2), Type of load: RS-422, TTL, Optocoupler, Pulse duty factor: 50% (in stepper motor mode), Output frequency: 200 µHz-500 kHz
The 750-670 module is an intelligent stepper controller used to control different drive power sections with pulse/direction interface or incremental encoder input.
RS-422 and 24V or 20mA interfaces can be used.
Due to the high output frequency, stepper output stages with smooth microstepping resolution can be used.
In addition, this module can also be used as a high-precision frequency or pulse width modulator.
Two configurable inputs for Start/Stop, limit switches, reference cams, Jog/Tip, etc., are evaluated directly and without any further delay by the internal software.
Versatile functions, such as positioning with different acceleration slopes, command tables, camshaft controller, auto referencing and other event-dependent properties provide this controller with a wide spectrum of possible uses
The programmer's interface is the same for all WAGO stepper controller modules.
Wago Fieldbus Coupler CANopen, MCS, Baud rate: 10kbaud-1Mbaud, Coupler conn.: (MSS) female connector 231-305/010-000, input process image max.: 512 Byte, output process image max.: 512 Byte, no. of PDO: 32 Tx/32 Rx, no. of SDO: 2 Server SDO
Wago 2-channel Analog Output, 0-10V, resolution: 12 Bit, short-circuit-proof, conversion time: ca. 2 ms
Wago Potential Distribution module, 8-way 24V and 8-way 0V, current via Power jumper contacts max.: DC 10A, voltage via Power jumper contacts max.: AC/DC 0-230V